Laser engraving machines can automatically identify the material

Laser engraving machines can automatically identify the material and measure engraving force with 98% accuracy using artificial intelligence

An interesting study was published recently:

With its AI capabilities, laserpecker 12 the laser engraving machine can engrave T-shirts made from mixed materials and automatically change the force to prevent cutting.

They installed their own AI on the laser engraving machine, laserpecker metal engraving which recognizes 30 different cutting technologies with 98% accuracy.

Additionally, it will tell you how fast and hard to cut/carve it.

As a rule of thumb, if this is a dangerous material, just throw a big "be careful" at you.

GIF for the cover

Therefore, there is no risk of human error (especially if the material is not mislabeled), toxic gases, or waste damage due to the cutting strength.

How would you make a protective mask out of three transparent plastic materials that look identical?

Give it to the AI! Brush a few times, the students' three analyses clearly were not in vain.

Polycarbonate is a dangerous material that cannot be cut (cutting can produce toxic fumes);

Cast propylene is used in the middle, which can be cut with a laser but cannot be wiped with alcohol;

On the far left, a clear sheet of plastic acetate can be rubbed with warm water and mild soap or alcohol.

For a lab mask, choose the leftmost one. Accept and complete it as follows:

GIF image for the cover

SensiCut AI can also be used for debugging laser engraving patterns:

Sensicut will tell you if the felt is too thin or the pattern design is too complex based on the thickness of each felt piece.

You can make it bigger before carving.

It will be a drag if you don't adjust as it says:

In addition, laser-assisted engraving of patterns can be performed on materials such as mobile phone cases and mixed-material clothing.

The traditional Chinese method of studying laser engraving on composite structural materials also requires data splitting and boundary alignment of their own design problems.

Along the way, did you find this feeling cut useful