Laser engraving machine routine maintenance maintenance rules

1. Linear guide rail lubrication:

Laser engraving machine after a long time of use, due to engraving and cutting smoke and dust generated by the guide rail has a corrosive effect, so you need to carry out regular maintenance of the guide rail.

First, turn off the power of the laser engraving machine and use a clean soft cloth to clean the guide rail.laserpecker compact laser engraver Then, drip lubricant on the guide rail and let the slider roll back and forth on the guide rail for a while to ensure that the lubricant can enter the inside of the slider. Next, install the guide rail, note that when installing the guide rail, do not fix it first, but first install the fixing pegs all the way up to keep it level. Finally, fix the belt with the slider, and install the lens, adjust the X-axis going direction can be completed.

2. Reflector and focusing mirror wipe:

After using the laser engraving machine and laser cutting machine for a period of time,laserpecker 11 smoke and dust will adhere to the surface of the lens, affecting the depth and precision of engraving and cutting. It is usually recommended to wipe three reflection mirrors and one focusing mirror carefully with anhydrous alcohol about every week (according to the frequency of use).

3. Bearing oiling:

The laser cutting machine uses a large number of bearings, in order to ensure good cutting and engraving results, some of the bearings need to be regularly refueled (except for oiled bearings). First, use a clean soft cloth to wipe off the floating soil on the bearings. Then, inhale the oil with a syringe and slowly inject it into the bearing with the needle. While filling the oil, just rotate the bearing slowly.

4. Tightening and loosening of the synchronous belt:

There are several synchronous belts in the transmission system in the laser cutting machine. If the synchronous belt is too loose, it will cause the engraving font to appear heavy shadow; if the synchronous belt is too tight, it will cause the synchronous belt to wear out. Therefore, after a period of use, it is necessary to adjust the synchronous belt tensioning screws to adjust the synchronous belt to the appropriate degree of tightness, so that the engraved text does not appear heavy shadow, and the operation noise of the laser engraving machine and the laser cutting machine is low as appropriate. If you need further guidance, you can consult the manufacturer's technical staff.

5. Laser tube maintenance:

The laser tube in the laser engraving machine is cooled by circulating water. After long-term use, some white scale may accumulate inside the tube. To remove this scale, you can add a small amount of vinegar to the circulating water. Then, use clean water to flush the inside of the laser tube through the circulation. This will keep the laser tube in optimal working condition and extend its life.

These are some common maintenance methods for laser engraving machines and laser cutting machines. Through regular guide rail lubrication, reflector and focusing mirror wiping, bearing oiling, synchronous belt elasticity adjustment and laser tube maintenance, you can ensure the normal operation of the equipment and extend its service life. When carrying out maintenance, you need to pay attention to safe operation and carry out maintenance accordingly to the specific model of the equipment and the frequency of use. If you have any questions or need further guidance, please consult the manufacturer's technical staff.